Wait a few minutes for the Mac to search for the Windows PC over WiFi. You will then see the option to “Connect.” Press that. You can use your Microsoft Account and its corresponding password, or the User ID and password for your account. The next step is to click “Registered User” and enter the username and password that you use to log into your Windows 10 computer. You can do this by right-clicking on the Start icon at the bottom left of the screen, and then click on “Run.” Type “cmd /k ipconfig /all” on the box that pops up. If you have no WiFi, then obtain a high-speed Ethernet cable to connect the two machines.Īdditionally, determine your Windows PC’s IP (internet protocol) address. To get started, you would have to procure a router so your Mac and PC can start talking to each other. Things You Need to Network a Mac and a PC Doing so will make you more productive, especially if you use both computers for work purposes. In fact, you can even network your PC and Mac so they could share a printer. This way, you will be able to share documents, photos, videos, etc. To save you lots of trouble, it is highly advisable to connect the two computers together over a network. But what if you decided to keep your old Windows PC? Using both machines at the same time will, at some point, require you to transfer files from one to the other. Switching from a PC to a Mac should be fairly easy with the right guide. Open up your internet browser and hit refresh.So you bought a new Mac computer. Select the DNS tab and input your DNS infoħ. Fill out the boxes according to your IP addressĥ.
Click on your Ethernet connection and where it says “Configure IPv4:” use the drop-down box to select “Manually”ģ. Open up Network Preferences with your adapter and Ethernet connectedĢ. Click "OK" and check your Ethernet connection. If you have any other questions, please contact us at #1ġ) Disconnect your Multi-Port Adapter from your computerģ) Manually remove "USB 10/100/1000 LAN" from your Network by clicking the "-" symbolĤ) Plug your Multi-Port Adapter back into your computerĥ) Manually add in "USB 10/100/1000 LAN" to your Network Preferences by clicking the "+" symbolĦ) After adding your Ethernet back in, please click on "Advanced" tabħ) In the "Advanced" tab, click on "Renew DHCP Lease" buttonĨ. If your issues still persist, move onto Set #2.
Follow Set #1 first and test your Ethernet again. Please note there are two sets of troubleshooting instructions. However, if you are experiencing any issues with your Ethernet connection, please follow the steps below. We hope you are enjoying your new Multi-Port Adapter!
0 kommentar(er)
